A.ldp explicit-null
B.mpls forwarding explicit-null
C.mpls ldp advertise-labels explicit null
D.mpls ldp explicit-null
您可能感兴趣的试卷
你可能感兴趣的试题
A. O IA
B. O E1
C. O E2
D. O
A.only the local OSPF routes
B.only the OSPF routes installed in the routing table
C.only the remotely learned OSPF routes
D.all the OSPF routes from the OSPF database that are eligible to be put in the routing table
A.VRF definition for IPv6
B.MP BGP for IPv6
C.LDP
D.VRF-enabled routing protocol
E.VRF-enabled interface
A.ipv6 router rip ccie distribute-list..
B.ipv6 router rip ccie offset-list..
C.interface e0/0 ipv6 rip ccie distribute-list..
D.interface e0/0 ipv6 rip ccie advertise..
A.Out-of-profile packets are queued.
B.It causes TCP retransmits.
C.Marking and remarking are not supported.
D.It does not respond to BECN and foresight messages.
E.It uses a single- and two-bucket mechanism for metering.
Refer to the exhibit. R2 and R3 are routers connected using Ethernet services from a service provider and can receive pings from each other. OSPF is configured as the routing protocol but adjacency is not happening. According to the output of the show commands in the exhibit, what could be the most likely cause of the problem? ()
A. Ethernet interfaces were configured as point-to-point.
B. Process IDs are not matching.
C. Configured bandwidths do not match on both interfaces.
D. Broadcasts and multicast are not being propagated over the Ethernet services.
E. OSPF cost does not match on both interfaces.
A.instances can control a selection of VLANs
B.load balancing
C.fast transition to forwarding state
D.backbone,uplink,and portfast (or equivalent)
E.root,loop,and BPDU guard (or equivalent)
A.the table of 4096 elements that map the respective VLAN to STP instance number
B.VTP version
C.configuration revision number
D.native VLAN ID
A.PIM sparse mode is being used.
B.PIM dense mode is being used.
C.The BGP multicast address family has not been configured.
D.IGMP version 3 is being used.
E.IP PIM neighbor filters have not been applied.
A.ip sla 1 icmp-echo 1.1.1.1 tos 160
B.ip sla 1 icmp-echo 1.1.1.1 tos 20
C.ip sla 1 icmp-echo 1.1.1.1 precedence 5
D.ip sla 1 icmp-echo 1.1.1.1 dscp 20
最新试题
Spanning Tree Protocol IEEE 802.1 s defines the ability to deploy which of these?()
Based on the exhibit presented. What will be the objective of this route map when applied to traffic passing through a router?()
What is the correct command to set the router ID for an OSPFv3 process?()
An expanding company is deploying leased lines between its main site and two remote sites. Thebandwidth of the leased lines is 128kb/s each,terminated on different serial interfaces on the main router.These links are used for combined VOIP and data traffic. The network administrator has implemented a VOIP solution to reduce costs,and has therefore reserved sufficient bandwidth in a low latency queue oneach interface for the VOIP traffic. Users now complain about bad voice quality although no drops areobserved in the low latency queue. What action will likely fix this problem?()
All of these are fundamental building blocks of differentiated services Traffic Conditioner Block exceptwhich one?()
Based on the output provided in the exhibit, to which address or location will the router forward a packet sent to 192.168.32.1?()
Which protocol and port have been assigned by IANA for RADIUS authentication?()
You are the network administrator of an enterprise with a main site and multiple remote sites. Your networkcarries both VOIP and data traffic. You agree with your service provider to classify VOIP and data trafficaccording to the different service RFCs. How can your data and VOIP traffic be marked?()
On the basis of the network provided in the exhibit, all routers are configured to run EIGRP on all links. If the link between PG-R1 and PG-R2 fails, what is the maximum number of queries PG-R3 will receive for 192.168.1.0/24, assuming that all the packets sent during convergence are transmitted once (there are no dropped or retransmitted packets)?()
What is also called Type 0 authentication in OSPF on Cisco Routers?()