多项选择题Which two multicast address ranges are assigned as source-specific multicast destination addresses andare reserved for use by source-specific applications and protocols? ()

A.232.0.0.0/8
B.239.0.0.0/8
C.232.0.0.0/4
D.FF3x::/32
E.FF2x::/32
F.FF3x::/16


您可能感兴趣的试卷

你可能感兴趣的试题

1.单项选择题

Refer to the exhibit. Look at the command output. What would be the most probable reason for this port-ID mismatch?()

A. spanning-tree misconfiguration
B. speed mismatch configuration
C. cabling problem
D. configuration problem

5.多项选择题Which three fields are optional in an OSPFv3 external LSA?()

A.Forwarding Address
B.External Route
C.Reference Link-State ID
D.Option
E.Prefix Options

6.多项选择题The network administrator is trying to add Switch1 to the network, but the 802.1Q trunk is not coming up. Switch1 was previously tested in the laboratory and its trunk configuration worked fine. What are three possible causes of this problem?()

A. The trunking configuration mode on Switch1 is set to Off.
B. The trunking configuration mode on the other end is set to On.
C. The trunking configuration mode on the other end is set to Desirable.
D. Cisco Discovery Protocol is not running on the other end.
E. There is a VTP domain name mismatch.
F. Switch1 does not support 802.1Q

7.多项选择题Which two statements are correct about Nonstop Forwarding?()

A.It allows the standby RP to take control of the device after a hardware or software fault on the active RP.
B.It is a Layer 3 function that works with SSO to minimize the amount of time a network is unavailable tousers following a switchover.
C.It is supported by the implementation of EIGRP, OSPF, RIPv2, and BGP protocols.
D.It synchronizes startup configuration, startup variables, and running configuration.
E.The main objective of NSF is to continue forwarding IP packets following a switchover.
F.Layer 2 802.1w or 802.1s must be used, as 802.1d cannot process the Layer 2 changes.
G.Routing protocol tuning parameters must be the same as the NSF parameters, or failover will beinconsistent.

8.单项选择题You are about to migrate a customer network to use a VSS. Which of these statements is true about a VSS? ()

A. The VSS switch must be the root bridge for all VLANs and is automatically designated
B. The VSS switch is defined in RFC 4318 as a managed object
C. The PAgP+ or LACP protocols are used to maintain the operational state of the VSS devices
D. A VSS interoperates with a virtual port channel
E. The 802.1Q or ISL protocols are used to maintain the operational state of the VSS devices
F. A VSS increases the size of the spanning-tree domain

9.单项选择题Which command can be used on a PE router to connect to a CE router (11.1.1.4) in VRF red?()

A.telnet 11.1.1.4 /vrf-source red
B.telnet 11.1.1.4 source /vrf red
C.telnet 11.1.1.4 /source vrf red
D.telnet 11.1.1.4 /vrf red
E.telnet 11.1.1.4 vrf red

10.单项选择题For which routes does LDP advertise a label binding?()

A.all routes in the routing table
B.only the IGP and BGP routes in the routing table
C.only the BGP routes in the routing table
D.only the IGP routes in the routing table

最新试题

Which two of these are used in the selection of a root bridge in a network utilizing Spanning Tree ProtocolIEEE 802.1 D?()

题型:多项选择题

Which of the following is true about the MPLS header and its EXP field size?()

题型:单项选择题

In order to configure two routers as anycast RPs, which of these requirements, af a minimum, must besatisfied?()

题型:单项选择题

Two routers configured to run BGP have been connected to a firewall, one on the inside interface and one on the outside interface. BGP has been configured so the two routers should peer, including the correctBGP session endpoint addresses and the correct BGP session hop-count limit EBGP multihop. What is agood first test to see if BGP will work across the firewall?()

题型:单项选择题

Choose two commands that are required to enable multicast on a router, when it is known that thereceivers use a specific functionality of IGMPv3.()

题型:多项选择题

Which command is used to enable SSM with the range 232.0.0.0 - 255.0.0.0?()

题型:单项选择题

Spanning Tree Protocol IEEE 802.1 s defines the ability to deploy which of these?()

题型:单项选择题

Which three protocols or applications should be placed in a class that is configured with WRED?()

题型:多项选择题

On the basis of the network provided in the exhibit, all routers are configured to run EIGRP on all links. If the link between PG-R1 and PG-R2 fails, what is the maximum number of queries PG-R3 will receive for 192.168.1.0/24, assuming that all the packets sent during convergence are transmitted once (there are no dropped or retransmitted packets)?()

题型:单项选择题

The classic Spanning Tree Protocol (802.1 D 1998) uses which sequence of variables to determine thebest received BPDU?()

题型:单项选择题