A.Dead
B.Establish
C.Network
D.Terminate
您可能感兴趣的试卷
你可能感兴趣的试题
A.Organization for Standards Institute
B.Organization for Internet Standards
C.Open Standards Institute
D.Open Systems Interconnection
A.to map a known DLCI to an IP address
B.to mapa known IP address to a MAC address
C.to map known SPID toa MAC address
D.to map a known DLCI to a MAC address
E.to map a known IP address to a SPID
F.to mapa known MAC address to an IP address
A.16
B.32
C.4095
D.4096
A.10.10.0.0/18 subnetted with mask 255.255.255.252
B.10.10.0.0/25 subnetted with mask 255.255.255.252
C.10.10.0.0/24 subnetted with mask 255.255.255.252
D.10.10.0.0/23 subnetted with mask 255.255.255.252
E.10.10.0.0/16 subnetted with mask 255.255.255.252
A.映射本地IP到对端端口值,以便路由器发送数据时确认发送端口
B.映射本地IP到本地端口值,以便路由器发送数据时确认发送端口
C.映射对端IP到本地端口值,以便X.25交换网络查找数据发送路径
D.映射对端IP到对端端口值,以便X.25交换网络查找数据发送路径
A.150.150.0.0
B.150.150.0.8
C.150.150.8.0
D.150.150.16.0
A.Network A - 172.16.3.48/26
B.Network A - 172.16.3.128/25
C.Network A - 172.16.3.192/26
D.Link A - 172.16.3.0/30
E.Link A - 172.16.3.40/30
F.Link A - 172.16.3.112/30
The switches shown in the diagram, Core and Core2, are both Catalyst 2950s. The addressing scheme for each company site is as follows:Router Ethernet port - 1st usable addressCore - 2nd usable addressCore2 - 3rd usable addressFor this network, which of the following commands must be configured on Core2 to allow it to be managed remotely from any subnet on the network? ()
A.Core2(config)# interface f0/0 Core2(config-if)# ip address 192.168.1.10 255.255.255.248
B.Core2(config)# interface vlan 1 Core2(config-if)# ip address 192.168.1.11 255.255.255.248
C.Core2(config)# line con 0 Core2(config-line)# password cisco
D.Core2(config)# line vty 0 4 Core2(config-line)# password cisco
E.Core2(config)# ip default-gateway 192.168.1.9
F.Core2(config)# ip route 0.0.0.0 0.0.0.0 192.168.1.8
A.a primary route,stored in the routing table
B.a backup route,stored in the routingt able
C.a backup route,stored in the topology table
D.A primary route,stored in the topology table
最新试题
请参见图示。主机A 尝试与主机C 建立TCP/IP 会话。在尝试期间,路由器Y 的FastEthernet 接口fa0/1捕获到一个帧。捕获的帧中包含源IP 地址为172.16.1.5而目的IP 地址为172.16.7.24的数据包。捕获该帧时,它的源MAC 地址是什么?()
请参见图示。网络中的主机A 正在向主机B 发送数据段。有关所交换的数据段的流量控制如图所示。下列关于此通信的陈述,哪两项是正确的?()
请参见图示。网络技术人员试图确定主机A 的正确IP 地址配置。以下哪一项是主机A 的有效配置?()
何时必须使用clock rate 命令配置路由器串行接口?()
请参见图示。对于从主机A 向Web 服务器发出的网页请求,正确的目的套接字数字是什么?()
OSI 哪一层可提供有序的数据重构服务?()
要将数据包发送到远程网络,应使用哪种设备?()
请参见图示。从主机X 发出的到主机Y 的tracert 命令已成功。下列哪一项正确地反映了追踪列表中显示的中间网络设备的顺序?()
请参见图示。网络中的所有设备均使用默认配置。此拓扑中需要多少个逻辑地址范围?()
请参见图示。图中所示路由表所属的PC 已正确配置。IP 地址192.168.1.254属于哪一个网络设备或接口?()