A.king valve and the expansion valve
B.solenoid valve and expansion valve
C.evaporator and receiver
D.compressor and evaporator
您可能感兴趣的试卷
你可能感兴趣的试题
A.discharge side of condenser
B.discharge side of compressor
C.outlet of the evaporator
D.receiver tank
A.increase the amount of cooling water to the condenser
B.decrease the amount of cooling water to the condenser
C.add more refrigerant to the system
D.remove some of the refrigerant from the system
A.the relief valve should open before the high-pressure cutout
B.the relief valve should open and let excess refrigerant go to receiver
C.the high-pressure cutout switch should operate before the relief valve opens
D.close in on the suction valve
A.finished joints
B.welded joints
C.ground joints
D.soldered joints
A.a clogged scale trap
B.air in the system
C.automatic controls not functioning properly
D.insufficient cooling water to the condenser
A.separating chamber
B.system of baffles
C.purge valve
D.vacuum reducing valve
A.saltwater side of the condenser
B.refrigerant side of the condenser
C.in the evaporator coils
D.in the suction strainer
A.cutout
B.pressure controller
C.controller switch
D.cutout switch
A.remove any air that may accumulate in the system
B.take out unpleasant fumes from the refrigerant
C.vent off excess refrigerant in an emergency
D.permit opening the refrigerating system for cleaning and inspecting
A.to increase the system efficiency by sensible heat transfer
B.to stop the liquid from flashing
C.to reduce the load on the compressor
D.to remove latent heat of vaporization and the suction piping transfer
最新试题
()connectors hold best if a wire is accidentally pulled or a connection becomes loose.
Which of the diesel engine components listed increase air density and helps to improve engine operating efficiency?()
When does auxiliary burner of incinerator put into operation? ()Ⅰ. start incinerator when it is coldⅡ. the sludge for dealing with is littleⅢ. the sludge for dealing with is largeⅣ. the water and impurity in sludge are too muchⅤ. the temperature in incinerator is lowⅥ. dealing with little solid rubbish
A purge recovery system is used in a centrifugal air conditioning or refrigeration system to ()
() is not installed on the main switchboar.
The main purpose of port State control is not to()
The flash point of a residual fuel oil should be used to determine the highest temperature to which oil may be heated()
Cold weather starting of a diesel engine may be made easier by()
During the diesel engine running, the water level of F.W expansion tank should normally kept in the () level of glass tube.
Engine parameters shall be corresponded to NOx Technical Files. This is required by ()