A.the relief valve should open before the high-pressure cutout
B.the relief valve should open and let excess refrigerant go to receiver
C.the high-pressure cutout switch should operate before the relief valve opens
D.close in on the suction valve
您可能感兴趣的试卷
你可能感兴趣的试题
A.finished joints
B.welded joints
C.ground joints
D.soldered joints
A.a clogged scale trap
B.air in the system
C.automatic controls not functioning properly
D.insufficient cooling water to the condenser
A.separating chamber
B.system of baffles
C.purge valve
D.vacuum reducing valve
A.saltwater side of the condenser
B.refrigerant side of the condenser
C.in the evaporator coils
D.in the suction strainer
A.cutout
B.pressure controller
C.controller switch
D.cutout switch
A.remove any air that may accumulate in the system
B.take out unpleasant fumes from the refrigerant
C.vent off excess refrigerant in an emergency
D.permit opening the refrigerating system for cleaning and inspecting
A.to increase the system efficiency by sensible heat transfer
B.to stop the liquid from flashing
C.to reduce the load on the compressor
D.to remove latent heat of vaporization and the suction piping transfer
A.its pressure and temperature are both lowered
B.its pressure and temperature are both raised
C.its pressure is lowered and its temperature is raised
D.its pressure is raised and its temperature is lowered
A.thermal valve
B.magnetic stop valve
C.bellows valve
D.bimetallic valve
A.high-pressure cutout switch is jammed open
B.low-pressure switch is jammed shut
C.thermal bulb is not operating properly
D.scale trap is clogged
最新试题
Thermostatic steam pressure reducing valves are used in the fuel oil service system to control the()
When does auxiliary burner of incinerator put into operation? ()Ⅰ. start incinerator when it is coldⅡ. the sludge for dealing with is littleⅢ. the sludge for dealing with is largeⅣ. the water and impurity in sludge are too muchⅤ. the temperature in incinerator is lowⅥ. dealing with little solid rubbish
To shut down a diesel engine after it exceeds the set maximum speed,which type of device listed should be used?()
Which one is NOT the ‘clear grounds’ for a more detailed inspection?()
To proceed to the assistance of a ship in distress is()
The treatment of the fuel oils involves storage, heating, filtering and()
During the diesel engine running, the water level of F.W expansion tank should normally kept in the () level of glass tube.
By comparing the exhaust gas temperature of each cylinder, the operator can determine if the load is balanced throughout the engine. The device most commonly used is a()
Under MARPOL Code the ship to which it applies has to carry ()
()connectors hold best if a wire is accidentally pulled or a connection becomes loose.