单项选择题Because the flow rate of supply water pump is too large, oily water separator does not work wellWhich of the following is not the reason?()

A.the monitoring equipment is out of order
B.separating effect becomes bad
C.inner wall is contaminated
D.separating effect becomes bad and inner wall is contaminated


您可能感兴趣的试卷

你可能感兴趣的试题

2.单项选择题The air-conditioner is running in the winter and to be stopped, we should()

A.close Fan and Humidifier at the same time
B.firstly close Fan and then close humidifier immediately
C.firstly close humidifier and then close Fan immediately
D.firstly close humidifier and then close Fan after 30 seconds

5.单项选择题In the management of the shafting, because() carry heavy load and caused high temperature easily, it should be paid attention.

A.the bearing near to the diesel engine
B.the intermediate bearing near to the thrust bearing
C.the intermediate bearing near to the sterntube
D.the bearing located at the middle of the diesel engine and the sterntube

7.单项选择题The bearing of tailshaft sealing equipment, which adopting the oil nature circulation is hot, the reason is()

A.the rotate speed fluctuation
B.the ventilation tube clogged
C.the main engine accelerate so fast
D.stormy waves

8.单项选择题The tailshaft sealing arrangement found a little lube oil leaky and caused a lot of seawater into the bearing, the step should be taken as a makeshift is()

A.dropping lube oil for lubrication, reducing the pollution to the sea
B.setting a temporary gravity oil tank and enhanced the position properly
C.lubricating with the used lube oil
D.lubricating with the fresh water and navigation in a lower speed

9.单项选择题When the vessel shafting are installed, the slightly inclined of the shaft line should be rectified by()

A.adjusting the position of the intermediate bearing
B.changing the position of the main engine installation
C.adjusting the center line of the propeller
D.changing the position of the thrust block

10.单项选择题Setting a sealing equipment astern on the tailshaft can’t ()

A.prevent the seawater from intergrating
B.prevent the lube oil from running out of the outside aboard
C.strengthen the intencity of the sterntube
D.prevent the mud and sand from entering the lube oil system