A.the rotate speed fluctuation
B.the ventilation tube clogged
C.the main engine accelerate so fast
D.stormy waves
您可能感兴趣的试卷
你可能感兴趣的试题
A.dropping lube oil for lubrication, reducing the pollution to the sea
B.setting a temporary gravity oil tank and enhanced the position properly
C.lubricating with the used lube oil
D.lubricating with the fresh water and navigation in a lower speed
A.adjusting the position of the intermediate bearing
B.changing the position of the main engine installation
C.adjusting the center line of the propeller
D.changing the position of the thrust block
A.prevent the seawater from intergrating
B.prevent the lube oil from running out of the outside aboard
C.strengthen the intencity of the sterntube
D.prevent the mud and sand from entering the lube oil system
A.on the sailing, the water in the aft peak tank should be excluded as much as possible
B.the stuffing style ahead sealing shouldn’t have any water leaking out
C.Simplex astern sealing shouldn’t have any oil leaking out
D.Simplex ahead sealing can have some oil leaking out
A.the good sealing performance and the simple structure
B.the good sealing performance and the short life expectancy
C.the good sealing performance but the short life expectancy
D.the good sealing performance and the lower cost
A.the shafting’s vertical vibration
B.violent friction and sea water corrosive
C.friction and high temperature
D.violent friction and high temperature
A.the border flange’s excursion and flection
B.the both end shafts line’s accordance
C.the border flange’s flection and the both end shafts line’s accordance
D.the border flange’s accordance and both end shafts flection degree
A.the stopping engine suddenly
B.the sailing astern and changing direction suddenly
C.the sailing from the shallow water area to the deep water area
D.the ship’s trim too much
A.after the thrust power is zero
B.after the torsion is zero
C.surpass the critical point on the water turbo phase
D.after the speed is zero
A.rapid reduction of ship’s friction force
B.shaft system over mechanical load
C.sharp growth of the torque of diesel engine
D.propeller torque change along J=0 curve
最新试题
For a given exhaust gas boiler, what is the quantity of its evaporation mainly determined?()
Thermostatic steam pressure reducing valves are used in the fuel oil service system to control the()
Engine parameters shall be corresponded to NOx Technical Files. This is required by ()
To shut down a diesel engine after it exceeds the set maximum speed,which type of device listed should be used?()
A purge recovery system is used in a centrifugal air conditioning or refrigeration system to ()
Which of the diesel engine components listed increase air density and helps to improve engine operating efficiency?()
Diesel engine air start system check valves are opened by ()
Flame failure in an automatically fired auxiliary boiler can from a/an ()
During the diesel engine running, the water level of F.W expansion tank should normally kept in the () level of glass tube.
The shipboard oil pollution emergency plan will be invalid after ()