A.made and noted as required by the duty engineer
B.reported to chief engineer immediately after being made by duty engineer
C.never made before getting permission from chief engineer
D.made as required but not logged
您可能感兴趣的试卷
你可能感兴趣的试题
A.the main propulsion plant
B.lifesaving jackets
C.lifeboat engine
D.state of emergency generator
A.the common ground point
B.the starter’s frame
C.the commutator
D.the starter’s mounting bolts
A.flame retardant
B.moisture resistant
C.oil resistant
D.low conductivity
A.Ring type
B.Fork type
C.Spade type
D.Push on pull off type
A.metal
B.wood
C.water
D.plastic
A.Stray current
B.Rated current
C.Starting current
D.Earth current
A.pump
B.the cylinder
C.the hunting gear
D.the rudder
A.transmitter
B.receiver
C.pipes
D.charging unit
A.transmitter
B.receiver
C.pipes
D.charging unit
A.hunting gear
B.cut-off level
C.servo-motor
D.swivel block
最新试题
To shut down a diesel engine after it exceeds the set maximum speed,which type of device listed should be used?()
“Insufficiency of manning or insufficiency of certification of seafarers” is an identification of a()
When does auxiliary burner of incinerator put into operation? ()Ⅰ. start incinerator when it is coldⅡ. the sludge for dealing with is littleⅢ. the sludge for dealing with is largeⅣ. the water and impurity in sludge are too muchⅤ. the temperature in incinerator is lowⅥ. dealing with little solid rubbish
Refrigerant entering the compressor of a refrigeration system should be in which of the following conditions?()
()connectors hold best if a wire is accidentally pulled or a connection becomes loose.
The cetane rating of diesel fuel is an indication of the ()
Which of the following items don’t belong to dock repair works?()
If two A.C.generators are to be operated in parallel, the load is distributed evenly by()
The flash point of a residual fuel oil should be used to determine the highest temperature to which oil may be heated()
By comparing the exhaust gas temperature of each cylinder, the operator can determine if the load is balanced throughout the engine. The device most commonly used is a()