A.corrosion on the gears
B.excessive gear speed
C.dirt in the oil
D.misalignment of the gears
您可能感兴趣的试卷
你可能感兴趣的试题
A.maintain alignment when the ship’s hull is working in heavy seas
B.ensure engine vibrations correspond to the natural frequency of the hull
C.permit the engine to expand away from the driven equipment as the engine heats up and expands
D.maintain engine thrust bearing clearances
A.must churn the oil in the sump
B.is connected to the propeller shaft
C.is driven at the highest RPM
D.compensates for alignment variations between the engine and pinion gear
A.reduce load
B.check your exhaust
C.adjust cooling water temperature
D.increase lube oil flow
A.Lubrication to the defective cylinder should be increased
B.Cooling water temperature to the engine should be increased
C.Only the turbocharger speed should be reduced
D.Engine speed should be reduced
A.incorrect injection timing
B.low exhaust back pressure
C.floating exhaust valves
D.excessive cranking speed
A.electrical overload
B.surging at governed RPM
C.loose engine mounting bolts
D.coolant leaking into the cylinder
A.check the air filter for obstruction
B.check for an exhaust leak
C.check the exhaust temperature
D.secure the engine
A.over-speeding of the engine
B.failure of the engine to shut down
C.no effect of engine mounting bolts
D.high exhaust temperatures
A.low lube oil temperature
B.low starting air temperature
C.air bubbles in the fuel oil system
D.water in the starting air system
A.Low cooling water outlet temperature
B.High lube oil pressure
C.Low lube oil temperature
D.Low starting air pressure
最新试题
Under MARPOL Code the ship to which it applies has to carry ()
Which one is NOT the ‘clear grounds’ for a more detailed inspection?()
The shipboard oil pollution emergency plan will be invalid after ()
The flash point of a residual fuel oil should be used to determine the highest temperature to which oil may be heated()
If separating effect is not good, which measure should be taken ()
If two A.C.generators are to be operated in parallel, the load is distributed evenly by()
Which of the listed governor characteristics will greatly affect the load sharing relationship between paralleled diesel generators?()
Thermostatic steam pressure reducing valves are used in the fuel oil service system to control the()
Engine parameters shall be corresponded to NOx Technical Files. This is required by ()
By comparing the exhaust gas temperature of each cylinder, the operator can determine if the load is balanced throughout the engine. The device most commonly used is a()