A.White
B.Black
C.Blue
D.Clear
您可能感兴趣的试卷
你可能感兴趣的试题
A.low ignition quality
B.a high volatility
C.low ignition delay
D.a high cetane number
A.inoperative turbocharger
B.inadequate fuel supply
C.overload on one cylinder
D.unequal load distribution
A.governor sensitivity
B.exhaust temperature
C.fuel injection pressure
D.speed of the can shaft
A.low air charge temperature
B.high cranking speed
C.excessive fuel dilution of lube oil
D.high compression pressure
A.fuel lines
B.lube oil filter
C.crank case pump
D.rocker arm reservoir
A.turn engine with jacking gear
B.drain filters and strainers and bleed off water at each injection pump
C.use ether to start the engine with blow-down valves open
D.blow through the cylinders and fuel lines with a drying agent
A.Compression ratio
B.Fuel/Air ratio
C.Compression pressure
D.Lube oil pressure
A.test the starting system
B.remove condensation from the cylinders
C.check the compression
D.check for proper lube oil pressure
A.turn the flywheel
B.reduce friction
C.overcome inertia
D.ignite the fuel
A.lower compression pressures
B.overheating without smoking
C.failure to start
D.a run away without load
最新试题
() is not installed on the main switchboar.
Engine parameters shall be corresponded to NOx Technical Files. This is required by ()
The condensers located in various stages of a flash evaporator are cooled by()
The flash point of a residual fuel oil should be used to determine the highest temperature to which oil may be heated()
()are used to digest the sewage to produce innocuous sludge in a biological sewage treatment plant.
By comparing the exhaust gas temperature of each cylinder, the operator can determine if the load is balanced throughout the engine. The device most commonly used is a()
When does auxiliary burner of incinerator put into operation? ()Ⅰ. start incinerator when it is coldⅡ. the sludge for dealing with is littleⅢ. the sludge for dealing with is largeⅣ. the water and impurity in sludge are too muchⅤ. the temperature in incinerator is lowⅥ. dealing with little solid rubbish
To shut down a diesel engine after it exceeds the set maximum speed,which type of device listed should be used?()
Flame failure in an automatically fired auxiliary boiler can from a/an ()
To proceed to the assistance of a ship in distress is()