A.detecting faulty combustion in individual cylinders
B.adjusting fuel racks to maintain equal loading between cylinders
C.adjusting the load limit setting of the governor at idle conditions
D.calculating engine horsepower
您可能感兴趣的试卷
你可能感兴趣的试题
A.tension load twice each crankshaft revolution
B.compression load during power and compression strokes
C.inertia load once every four crankshaft revolutions
D.bending loads at bottom and top dead center
A.cooling water leaving each cylinder
B.fuel oil entering the injector
C.exhaust gases at various locations
D.lube oil at the bearing supplies
A.low water in the expansion tank
B.improperly seated valves
C.low fuel oil pressure
D.worn or broken cylinder liner sealing rings
A.exhaust
B.fuel oil
C.cooling water
D.cylinder liner
A.improperly seating intake valves
B.leaking cylinder liner seal rings
C.late fuel injection timing
D.carbon deposits on the piston
A.piston skirt
B.pinion
C.crosshead
D.compression rings
A.cylinder pressure
B.flame intensity
C.exhaust gas temperature
D.crankshaft axial alignment
A.decreased compression pressure
B.increased lube oil pressure
C.lower lube oil temperature
D.excessive leakage past the piston rings
A.dwell-tachometer
B.exhaust gas pyrometer
C.fuel flow rate mete
D.exhaust gas analyzer
A.worn or broken cylinder liner sealing rings
B.high cooling water temperature
C.worn or broken piston rings
D.low fuel oil pressure
最新试题
The condensers located in various stages of a flash evaporator are cooled by()
Cold weather starting of a diesel engine may be made easier by()
Which of the listed governor characteristics will greatly affect the load sharing relationship between paralleled diesel generators?()
Which one is NOT the ‘clear grounds’ for a more detailed inspection?()
To proceed to the assistance of a ship in distress is()
Refrigerant entering the compressor of a refrigeration system should be in which of the following conditions?()
A purge recovery system is used in a centrifugal air conditioning or refrigeration system to ()
()connectors hold best if a wire is accidentally pulled or a connection becomes loose.
When does auxiliary burner of incinerator put into operation? ()Ⅰ. start incinerator when it is coldⅡ. the sludge for dealing with is littleⅢ. the sludge for dealing with is largeⅣ. the water and impurity in sludge are too muchⅤ. the temperature in incinerator is lowⅥ. dealing with little solid rubbish
Flame failure in an automatically fired auxiliary boiler can from a/an ()