A.excessive ring action
B.excessive ring temperature
C.improper ring rotation
D.excessive ring face wear
您可能感兴趣的试卷
你可能感兴趣的试题
A.higher speed required
B.flywheel-effect
C.lower starting temperatures
D.higher compression pressures
A.most critical in a four-stroke cycle diesel engine
B.most critical in a two-stroke/cycle diesel engine
C.most critical in a four-stroke/cycle diesel engine if it is turbocharged
D.of equal importance in a two-stroke/cycle diesel engine as in a four-stroke/cycle diesel engine
A.The oil control rings will seal improperly and wear rapidly
B.The piston will overheat due to insufficient lubrication
C.Excessive oil will remain on the cylinder wall
D.Light brown smoke will emanate from the engine exhaust
A.keep piston crown temperatures elevated for smoother combustion
B.reduce the possibility of overheating the top compression ring
C.help retain the heat of compression to prevent ignition delay
D.help retain the heat of compression to prevent combustion knock
A.dispersant additives
B.floc point
C.alkalinity additives
D.ignition quality
A.starting the engine hot
B.knurling the piston skirt
C.operating an overheated engine
D.using scuff resistant piston rings
A.the amount of lube oil additives increase
B.piston speeds increase
C.injection pressure decrease
D.engine speeds decrease
A.less piston slap and quieter running
B.increased crankshaft bearing wear
C.slightly greater piston wear
D.decreased side pressures
A.Liner wear is distributed equally between the upper and lower portions of the cylinder
B.Excessive liner wear causes wear between piston ring and groove
C.Excessive, but uniform liner wear will not cause wear between piston ring and groove
D.Liner wear is normally greatest in the middle of the cylinder
A.alternation of side thrust
B.a breakdown of the lube oil film on the cylinder wall
C.worn piston boss piston pin bearings
D.fluctuating gas pressure in the combustion space
最新试题
The main purpose of port State control is not to()
()are used to digest the sewage to produce innocuous sludge in a biological sewage treatment plant.
When does auxiliary burner of incinerator put into operation? ()Ⅰ. start incinerator when it is coldⅡ. the sludge for dealing with is littleⅢ. the sludge for dealing with is largeⅣ. the water and impurity in sludge are too muchⅤ. the temperature in incinerator is lowⅥ. dealing with little solid rubbish
The condensers located in various stages of a flash evaporator are cooled by()
Which of the listed governor characteristics will greatly affect the load sharing relationship between paralleled diesel generators?()
Which of the following items don’t belong to dock repair works?()
Thermostatic steam pressure reducing valves are used in the fuel oil service system to control the()
As soon as a diesel engine has started, which of the listed engine operating parameters should be checked FIRST?()
()connectors hold best if a wire is accidentally pulled or a connection becomes loose.
If separating effect is not good, which measure should be taken ()