A.use of low viscosity oil in cold weather
B.increased moisture content of inlet air in cold weather
C.increased drag of pistons and bearings due to increased oil viscosity
D.higher compression pressures reached due to smaller clearances existing in the engine during cold weather
您可能感兴趣的试卷
你可能感兴趣的试题
A.octane number
B.cetane number
C.viscosity in Saybolt seconds
D.air fuel ratio
A.Decreasing scavenge air pressure
B.Increasing exhaust temperatures before the turbine
C.Reduction in engine speed
D.All of the above
A.quality of air filtration
B.effectiveness of lubrication
C.type of fuel used
D.all of the above
A.cetane number
B.octane number
C.ignition index number
D.volatility point
A.antiknock characteristics
B.ignition qualities
C.rates of vaporization
D.viscosity
A.increase in starting air pressure
B.increase in lube oil viscosity
C.compression expansion device
D.jacket water heater
A.corrosion and grooving of exhaust valves
B.corrosion and gumming of the fuel injection pump
C.salt deposits in the exhaust manifold
D.slag deposits in the fuel injection equipment
A.clogged fuel injection pumps
B.increased cylinder liner wear
C.intake valve stem corrosion
D.varnish deposit on pistons
A.Injection lag
B.Lube oil dilution
C.Pre-ignition
D.Corrosion
A.increase thermal efficiency
B.cause clogging of the fuel system
C.increase the ability of the engine to start in cold weather
D.produce corrosion in the cylinder and exhaust system at low loads
最新试题
Engine parameters shall be corresponded to NOx Technical Files. This is required by ()
The shipboard oil pollution emergency plan will be invalid after ()
Cold weather starting of a diesel engine may be made easier by()
“Insufficiency of manning or insufficiency of certification of seafarers” is an identification of a()
During the diesel engine running, the water level of F.W expansion tank should normally kept in the () level of glass tube.
One of the reasons that cause oil flowed from sludge outlet of a self-cleaning separator is()
Thermostatic steam pressure reducing valves are used in the fuel oil service system to control the()
If two A.C.generators are to be operated in parallel, the load is distributed evenly by()
Using a file without a handle may result in ()
The condensers located in various stages of a flash evaporator are cooled by()