A.has continuously for a long period
B.suction pressure is below normal
C.oil level is below normal
D.starts after a long idle period
您可能感兴趣的试卷
你可能感兴趣的试题
A.protect the pump from fine soluble contaminants
B.prevent solid particles from entering the pump
C.prevent solid particles from entering the filter
D.protect the directional control valves
A.Feed-water heater internal tube surfaces
B.Internal distillate cooler tubes
C.Flash chamber vertical surfaces
D.Distilling condenser tubes
A.Reduction of friction
B.Insulation of hot surfaces
C.Lubrication of moving parts
D.Elevation of cooler outlet temperatures
A.higher boiling temperature for a given pressure than does a pure refrigerant
B.lower boiling temperature for a given pressure than does a pure refrigerant
C.boiling pressure equal to that of a pure refrigerant at a given pressure
D.boiling point will not be affected by entrained oil
A.Degree of saturation
B.Saturation temperature
C.Superheated temperature
D.Degree of superheat
A.pump must always be primed
B.volute must impart a radial and rotary motion of the water suction side
C.connection must guide the liquid to the lantern rings
D.stuffing box should not be allowed any water leakage
A.change in impeller diameter
B.square of the impeller diameter
C.cube of the impeller diameter
D.impeller efficiency for large changes in the size of the impeller
A.the suction pressure to decrease
B.the suction temperature to increase
C.increased ice formation on the evaporator coil
D.excessive short cycling of the compressor
A.Lobe
B.Screw
C.Radial piston
D.Volute
A.They are particularly suited for pumping high viscosity fluids
B.They are started with the discharge valve opened
C.The flow of liquid is developed by imparting energy due to the rotation of an impeller
D.They are always mounted in a horizontal position
最新试题
Which of the following statements is correct concerning heat transfer?()
If the relief valve on the discharge side of a hydraulic pump lifts, the cause could be ().
Which of the listed pumps is NOT a positive displacement pump?()
A gradual decrease in the discharge pressure of an operating hydraulic pump can be caused by ().
Heavy wear in a particular area of the inner circumference of a packing ring may be caused by ().
The major source of chemical contaminants in hydraulic fluid is ().
If you are given the job of adding hydraulic fluid to a mooring winch, and are not certain as to the type of fluid to use, you should ().
The output volume of a positive fixed displacement pump can be changed only by ().
An internal bypass is provided on some hydraulic system suction strainers to help reduce the possibility of ().
Pitting in the suction areas of a centrifugal pump bronze impeller is usually caused by ().