A.Accidental discharge of oil
B.Disposal of oil residues
C.Quantity of water produced by FWG
D.Discharge of dirty ballast or cleaning water from fuel oil tanks
您可能感兴趣的试卷
你可能感兴趣的试题
A.strangers
B.relief valves
C.emergency valves
D.strainers
A.proceeding
B.overloading
C.collision
D.flooding
A.every oil tanker
B.every ship of 400 tons gross tonnage and above
C.A and B
D.Neither A nor B
A.Non automatic discharge overboard of machinery space bilge water
B.Automatic discharge overboard of machinery space bilge water
C.A and B
D.Neither A nor B
A.open
B.close
C.remain in its position
D.flood the evaporator with refrigerant
A.low water level
B.low oil pressure
C.excessively high fuel pressure
D.an improper air/fuel ratio
A.Condenser leakage
B.A shortage of liquid refrigerant
C.Excessive frost on the evaporator
D.Not enough condenser cooling water
A.high discharge pressure
B.frosting of the crankcase
C.high temperature of the overboard water
D.low suction pressure of compressor
A.upper part of the receiver
B.upper part of the condenser
C.down stream end of the cooling coil
D.outlet end of the condenser
A.icing of the automatic controls
B.embrittlement of some parts of the automatic controls
C.sludge in the lubricating oil
D.all of the above
最新试题
A gradual decrease in the discharge pressure of an operating hydraulic pump can be caused by ().
When a refrigeration compressor has developed a high head pressure as a result of a refrigerant overcharge, you should ().
The amount of fluid friction or internal friction inherent in a mineral lubricating oil is reflected as a measure of its ().
Which of the following statements is correct concerning heat transfer?()
Heavy wear in a particular area of the inner circumference of a packing ring may be caused by ().
If you are given the job of adding hydraulic fluid to a mooring winch, and are not certain as to the type of fluid to use, you should ().
The rate of heat transfer between the hot and cold fluids passing through a shell-and-tube type heat exchanger will ().
The rate of heat transfer from a hot region to a cold region is affected most by the ().
The usual symptoms of cavitation in a centrifugal pump is ().
If the suction pressure at the refrigeration compressor is below normal, the cause can be().